Installing the Customer Changeable Developer


  1. Align the cart (5) with the printer and push it forward to engage it. Align the rails on the cart with the rails of the developer frame in the printer.
    align cart with rails on printer
  2. Raise the top of the cart by turning the handle (6) clockwise until it stops. The cart will now be locked to the printer frame.
  3. Ensure that the scavenger roll tab is down so that the drum doesn't get scratched.
  4. Pull and hold the safety latch (8) on the front of the developer cart.
  5. Grasp the handle on the developer and push it forward slowly onto the developer rails in the printer, until it is all the way back in the developer frame.
    push developer onto developer rails
  6. Lower the top of the cart by turning the handle (6) counterclockwise until it stops.
    lower cart top
  7. Press the foot release pedal (7) down and pull the cart away from the printer.
  8. Push up on the scavenger roll tab (1), so it is in the vertical position.
    scavenger roll tab
  9. Using the blue arrows to correctly align the developer communications cable, connect the cable (4) to the connector on the front of the developer.
    drum cover
  10. Close and latch the drum cover (3) by turning the handle (2) counterclockwise.
  11. Close the right front cover of the printer.
  12. Select OK and then Check/Reset on the touch panel.