8.0" Forms Width Support feature (RPQ 8B5045)

RPQ 8B5045 must be installed and enabled to use this feature. Your service representative must install all special features.

Do this procedure to enable or disable the Forms Width Support feature.

With this feature, hardware changes are made to the engine to allow the tractors to be moved as close as 8.0 inches apart so that 8-inch forms may be printed. When this feature is installed, the printer can run in tractorless mode only.


  1. Select Printer Definition -> Features to display the Features panel.
  2. Select 8B5045.
  3. Select Enable or Disable.
  4. Select Close.