Previous Page | Next Page Contents Glossary Index Operating the printer >

Enabling and disabling pre/postprocessors

The service representative configures any attached preprocessors and postprocessors when they are installed and sets the state of each device to Enabled or Disabled.

If you change the enabled status of a burster/trimmer/stacker (BTS) or an offsetter postprocessing device, you must make configuration changes in the Printer Definition -> Pre/postprocessing procedure. (Refer to the Planning and Configuration Guide.)

For all other types of postprocessing devices and for all preprocessing devices, you can make status changes only in the Frequent Tasks -> Pre/postprocessors procedure.

Do this task whenever you need to functionally connect (enable) the printer to the processor.

  1. Select Frequents Tasks -> Pre/postprocessors.
  2. Select a processor in the Processor Name list. The status displays next to the processor.
  3. Select Enable or Disable.
When the internal stacker is enabled on the Infoprint 4100 Models HS2 in simplex mode or the HD3/4 in dual simplex mode, the printer speed must be set to low. Select Printer Definition->Printer->Basic and select Low for Printer Speed.