Previous Page | Next Page Contents Glossary Index Operating the Printer >

Enabling/Disabling Pre/Post Interfaces

The service representative configures attached preprocessing and postprocessing devices at time of their installation and sets the state of each device to Enabled or Disabled. As configurations change from time to time, you may have to change the preprocessing/postprocessing device interface configurations and to enable or disable the devices. Make these changes from the Display/Touch Screen windows.

If a burster/trimmer/stacker (BTS) or an offsetter postprocessing device is to have its enabled status changed, you must make configuration changes in both the Configure Printer procedure (see Configuring the Printer) and in the Configure Pre/Postprocessor procedure (see Configuring Preprocessing/Postprocessing Devices/Interfaces).

For all other types of postprocessing devices and for all preprocessing devices, you have to make enabled status changes in only the Configure Pre/Post procedure.