Previous Page | Next Page Contents Glossary Index Working With Forms >

Using the Printer Stacker with a Postprocessing Device

If a postprocessing device is disabled or not yet configured, you may continue to use boxed forms and the printer stacker. If the postprocessing device includes any rollers, sensors, or any other hardware that would interfere with the operation of the stacker, you must remove those interferences before you attempt to use the stacker.

If the "Stacker Enabled" configuration item under the Configure Printer procedure is set to Yes and there are no postprocessing devices installed and enabled on the printer, the stacker table automatically rises when printing begins. To raise the stacker table manually, press the stacker table UP key on the stacker control panel.

If a postprocessing device is installed on a printer and is enabled, the stacker table is lowered and is prevented from moving upward. The pendulum and other devices in the stacker are also prevented from operating.

In duplex mode, the stacker in Printer 1 is always disabled as if a postprocessing device were installed and enabled.